RP6 ROBOT SYSTEM - 3. RobotLoader 2
ver
Display the firmware version.
show rssi
Display the current signal strength.
scan
Scan for access points
show status
Display current status
show net
Display current network status
get everything
Display all settings
get wlan
Display WLAN settings
get ip
Display IP settings
get comm
Display communication parameters
set ip adr 192.168.10.171
Set IP address
set ip mask 255.255.255.0
Set network mask
set ip gateway 192.168.10.1
Set gateway
set ip dhcp 0
Deactivate DHCP
set wlan join 1
Connection mode to access point
set wlan ssid M256TST
Use access point with SSID M256TST
set wlan auth 4
Use WPA2 access points with automatic connection to
the next access point
set wlan passphrase <PASS>
Set WPA passphrase
set wlan hide 1
Hide WPA passphrase (for get command)
set wlan linkmon 5
Send every 5 seconds UDP broadcast on port 55555 and
check connection to the access point.
set comm size 1024
Set network packet size. Here: if 1024 characters are in
the buffer, send network packet.
set comm time 10
Set Timeout for the transmission of the network packet.
Here: if no new data have been received for 10ms via
the serial interface, send network packet.
save
Save settings in the flash ROM
exit
Quit command mode
reboot
Re-start module
As already said, the table is far from being complete and gives just a quick idea. You
don't have to do all this by yourself as the RobotLoader can make these settings for
you.
- 25 -
