connected to the module. The registration process will
only need to be completed once with the same email used
as email #1. After the registration is complete, the same
email can be used to setup other WiFi modules and they
will be automatically added to the same account.
1. You will receive an email, in a few short minutes, from
GlentronicsConnect.com at the provided email address
(email #1) with instructions on how to complete
the registration
2. The registration email will include your temporary password.
Write it down in order to complete the registration
3. Click on the ‘Complete Registration’ link in the lower
left and it will take you to the Glentronics Connect website
4. This page will contain all your entered information.
Input your temporary password and click continue
Note: We recommend logging into your account and changing
your temporary password by going into the user profile page.
5. This will complete your registration process.
You are now set up, although we recommend you
proceed to section 8 for a functionality test
(8) Testing the setup
1. Disconnect the power to the sump pump system
connected to the WiFi module
(a) Within a few minutes you will receive an email
(b) If you used the USB connection, it will state that
the unit is not receiving AC power
(c) If you used the remote terminal to connect, it will
state that the pump system is alarming
2. Reconnect the power to the sump pump system
(a) Within a few minutes you will receive an email
(b) If you used the USB, it will indicate that the system
is operating properly
(c) If you used the remote terminal, it will indicate
that the alarm has been cleared
3. You can perform this test with other alarms and you will
receive an email with the corresponding notification.
We recommend that you look through Sections 9 and 10
for your knowledge and understanding
(9) The Glentronics Connect website
This section will explain each page on the Glentronics Connect
Website. Use this website to stay connected to your
Glentronics pump system. It can be accessed by going to
www.glentronicsconnect.com and using your credentials
to log in.
1.
The Devices tab to the
WiFi Modules page
This page will allow the
user to edit the infor-
mation entered during
the setup process. It will
also allow enabling of
the following options:
(a) Receive notifications
enabled as a default.
Can
disable if the
user does not want to
receive notifications
(b)
Allow automatic
updates – disabled as
a default. Can enable
if the user wants to
allow automatic
firmware downloads. If enabled, when new firmware
is available, the WiFi module will automatically
download within 24 hours.
(c) Used as a high water alarm - disabled as default.
Check this box when there is a high water detector
(float or contacts) connected to the remote
terminals, or used as a WiFi water alarm
2.
The Profile tab to the User Profile page
This page will store the user’s information and can be
edited at any time. This page is also used to change the
password. Changing the provided temporary password to
your own is recommended after registration is complete.
3.
The Status tab to the Status page
This page will display the status of the unit that is
connected to your WiFi module. The latest registered
WiFi module will display the status on the screen. If
8