List of compatible models:
1730 (since 2014)
2400 (since 2006)
PS-C22 (since 2014)
PS-C33 (since 2006)
3. If you are attaching to a Deluxe Float Controller
(DFC2, VSC2 or TSC2) with a USB port:
Go to section 2C
List of compatible models
DFC2 (since 2017)
VSC2 (since 2017)
TSC2 (since 2018)
4. If you are attaching to a Deluxe Float Controller
(DFC2, VSC2, TSC2 or DVSA) with a remote terminal:
Go to section 2D
List of compatible models
DFC2 (2016 and older)
VSC2 (2016 and older)
DVSA
(all)
5. If you are using the module as a Wi-Fi water alarm:
Go to section 4
(2) Attach your WiFi module to your Pro Series
system
(see diagram sheet for visual help)
Note: The WiFi module must receive 115V AC +/- 5% and
60 Hz from the AC outlet to function correctly
2A. Attaching your WiFi module to your Pro Series
backup system with a USB port
This section will explain how to connect your WiFi module
to your backup sump pump system using the included
micro USB cable. Using the micro USB cable will provide
a specific notification email explaining exactly which
alarm is activated on the system it is connected to. This
connection style is only compatible with CONNECT models
which include a USB port.
1. Using the Micro USB cable.
Connect the micro end into
the Data port located on the
front of the module in the
lower right corner.
2. Connect the standard USB end into
the USB port on the backup sump
pump controller
Note: When using the data
connection, no other cable is
necessary; this cable will also power the WiFi module.
However, we recommend connecting the mini USB cable and
USB charger in order to provide an additional power source
to the WiFi module.
3. Connect the USB charger to
the WiFi module using the
included mini USB cable
4. Plug the other end of the
USB charger into your
power outlet
5. The red and green lights on the WiFi module should
start alternating
(a) This means that it is ready for setup
Note: In order to receive notification during a power outage,
you must have a Wi-Fi router / modem with a built-in
battery backup or an uninterruptible power supply (UPS)
powering the equipment.
Proceed to section 5 (Mounting your WiFi module)
2B. Attaching your WiFi module to your Pro Series
backup system with a remote terminal
This section will explain how to connect your WiFi
Module to your backup sump pump system using the
remote terminal and the included remote terminal cable.
Using the remote terminal cable will provide a general
notification stating that your system is alarming. This
connection style is compatible with all models that
include a remote terminal.
Note: This connection style should not be used if your
backup is a Pro Series Connect and has a USB port.
You will only connect via the USB port.
Note: you will not receive remote notification for low fluid
in the battery when using the remote terminal connection.
2