(a) If you will be using this in a sump pit, sewage pit,
or other area that can handle a 3/8” depth, proceed to
Section 4-1.
(b) If you will be using this in an area where you need to
know when there is minimal buildup of water, proceed
to Section 4-2.
1.
If you will be using this in a sump
pit, sewage pit, or other area that
can handle a 3/8” depth, you
need the following accessory:
(a) High Water Float (HWF)
This accessory can be ordered by calling
our office at: 1-800-991-0466
Once you have the part:
(a) Mount the High Water Float (HWF) with the float ball
below the ‘L’ bracket. If using in a sump or sewage pit,
use the included stainless steel hose clamp.
(b) Attach the wire labeled ‘NO’ to
the Normally Open port labeled
‘NO’ on the right side of the WiFi
module. Turn the screw clockwise
to secure the wire.
(c) On the same end of the wire, attach the wire end labeled
‘COM’ to the Common port labeled ‘COM’ on the right side of
the WiFi module. Turn the screw clockwise to secure the wire.
(d) Install four AA-batteries into the 6V Battery pack
(e) Plug the battery pack into the 12V/6V DC port on the
bottom of the module
Note: make sure the slide switch on the battery pack is in
the ‘ON’ position
Proceed to Section 5 (Mounting your WiFi module)
2.
If you will be using this in an area where you need to
know when there is minimal buildup of water, you need
the following accessory:
(a) High Water Contacts (HWC) (Available late 2018)
This accessory can be ordered by calling
our office at: 1-800-991-0466
Once you have the part:
(a) Mount the High Water Contacts (HWC) with the sensor
pads down and secure in place using the holes in the
sensor panel
(b) Attach the other end of the wire
labeled ‘NO’ to the Normally Open
port labeled ‘NO’ on the right side
of the WiFi module. Turn the
screw clockwise to secure the wire.
(c) On the same end of the wire,
attach the wire end labeled ‘COM’ to the Common port
labeled ‘COM’ on the right side of the WiFi module. Turn
the screw clockwise to secure the wire.
(d) Install four AA-batteries into the 6V Battery pack
(e) Plug the battery pack into the 12V/6V DC port on the
bottom of the module
Note: make sure the slide switch on the battery pack is in
the ‘ON’ position
Proceed to Section 5 (Mounting your WiFi module)
(5) Mounting your WiFi module
You may use either method below
to mount your WiFi module
Notice: Do not expose the WiFi
module to any type of moisture,
water, rain or snow.
Notice: Protect the cords from sharp
objects. Avoid kinking the cords.
1. Using the Velcro, mount your WiFi module
(a) Peel and stick one side of the Velcro into the
recessed rectangle on the back of the module
(b) Peel and stick the other piece of Velcro where you
would like to mount the module (within 3 feet of
the backup or deluxe controller)
• Top of the battery box
• Top of the backup control box
• To the wall
6
HWF