9. Attach the smaller ringlug labeled negative (-), to the
negative post of the battery.
10. Plug the power jack at the other
end of the wire into the 12V/6V DC
Battery port on the bottom of
the Module.
Note: In order to receive notification
during a power outage, you must have
a Wi-Fi router / modem with a built-in battery backup or an
uninterruptible power supply (UPS) powering the equipment.
Proceed to section 5 (Mounting your WiFi module)
11.
Install four AA-batteries into the 6V Battery pack
12. Make sure the switch on the battery pack is in the
‘ON’ position
13. Plug the battery pack into the 12V/6V DC port on the
bottom of the module
Note: In order to receive notification during a power outage,
you must have a Wi-Fi router / modem with a built-in
battery backup or an uninterruptible power supply (UPS)
powering the equipment.
Proceed to section 5 (Mounting your WiFi module)
(3) Accessories
When connected using a USB port, it is possible to add a
high water detector using either a float (HWF) or contacts
(HWC). If water reaches the water detector, the WiFi module
will send a text or email to the designated locations stating
that high water is present.
1.
If you will be using this in a sump
pit, sewage pit, or other area that
can handle a 3/8” depth, you
need the following accessory:
(a) High Water Float (HWF)
This accessory can be ordered by calling
our office at: 1-800-991-0466
Once you have the part:
(a) Mount the High Water Float (HWF) with the float ball
below the ‘L’ bracket. If using in a sump or sewage pit,
use the included stainless steel hose clamp.
(b) Attach the wire labeled ‘NO’ to
the Normally Open port labeled
‘NO’ on the right side of the WiFi
module. Turn the screw clockwise
to secure the wire.
(c) On the same end of the wire, attach the wire end labeled
‘COM’ to the Common port labeled ‘COM’ on the right side of
the WiFi module. Turn the screw clockwise to secure the wire.
Note: Be sure to check the ‘Used as high water alarm’ checkbox
in the ‘Devices tab’ of the ‘WiFi Modules page’. See section 9-1-C
Proceed to Section 5 (Mounting your WiFi module)
2.
If you will be using this in an area where you need to
know when there is minimal buildup of water, you need
the following accessory:
(a) High Water Contact (HWC) (Available late 2018)
This accessory can be ordered by calling our office
at: 1-800-991-0466
Once you have the part:
(a) Mount the High Water Contacts (HWC) with the sensor
pads down and secure in place using the holes in the
sensor panel
(b) Attach the wire labeled ‘NO’ to the Normally Open port
labeled ‘NO’ on the right side of
the WiFi module. Turn the screw
clockwise to secure the wire.
(c) On the same end of the wire,
attach the wire end labeled ‘COM’
to the Common port labeled ‘COM’
on the right side of the WiFi module. Turn the screw
clockwise to secure the wire.
Proceed to Section 5 (Mounting your WiFi module)
(4) When Using as a Wi-Fi alarm only
The Pro Series Pumps WiFi module is designed so that it
can be used as a standalone Wi-Fi water alarm (additional
accessories are required). If water reaches the water
detector, the WiFi module will send a text or email to the
designated locations stating that high water is present.
5
HWF