1. Using the 3 foot remote
terminal cable, attach
one end of the cable
labeled ‘NO’ to the
Normally Open port
labeled ‘NO’ on the
back or side of the
backup system control box. Turn the screw clockwise
to secure the wire.
2. On the same end of the remote terminal cable, attach
the cable end labeled ‘COM’ to the Common port labeled
‘COM’ on the back or side of the backup system control
box. Turn the screw clockwise to secure the wire.
3. Attach the other end of the
cable labeled ‘NO’ to the
Normally Open port labeled
‘NO’ on the right side of the
WiFi module. Turn the screw
clockwise to secure the wire.
4. On the same end of the remote terminal cable, attach
the cable end labeled ‘COM’ to the Common port labeled
‘COM’ on the right side of the WiFi module. Turn the
screw clockwise to secure the wire.
5. Connect the USB charger
to the WiFi module using
the included mini USB
cable
6. Plug the other end of the
USB charger into your power outlet
7. The red and green lights on the WiFi module should
start alternating. This means that it is ready for setup.
Note: In order to get your messages during a power outage,
we recommend using the 12 volt battery providing backup
power to your backup system.
8. Using the 6 foot, 12 volt battery cable, attach the large
ringlug labeled ‘positive’ (+), to the positive post of
the battery.
9. Attach the smaller
ringlug labeled
negative (-), to the
negative post of the
battery.
10. Plug the power jack
at the other end of the wire
into the 12V/6V DC Battery port
on the bottom of the Module.
Note: In order to receive
notification during a power
outage, you must have a Wi-Fi
router / modem with a built-in battery backup or an
uninterruptible power supply (UPS) powering the equipment.
Proceed to section 5 (Mounting your WiFi module)
2C. Attaching your WiFi Module to your
Deluxe Float controller with a USB
This section will explain how to connect your WiFi Module
to your Deluxe Float Controller using the included micro
USB cable. Using the micro USB cable will allow for
a specific notification email explaining exactly which
warning is alarming on the system it is connected to. This
connection style is only compatible with CONNECT models
which include a USB port.
1. Using the Micro USB Cable.
Connect the micro end into the
Data port of the WiFi module
2. Connect the USB end into
the USB port on the pump
controller
3. Mini USB Cable. Connect the
mini end into the 5VDC Power
port on the bottom of the
module
4. Connect the USB end into
the 5V 1A USB Charger
5. Plug the charger into
your outlet
-
+
3