22/06/2010 MT04_A30_B_VI110L_GIVI_ENG REV.B
9
32
STORING OF PROGRAMMES AND DATA
The programming of counter
VISION 110
is carried out by the Manufacturer who
knows the access codes and the procedures (configuration). The operator can
carry out all operations. All the information is stored permanently and can be only
modified by reforming it all from the beginning.
Furthermore, the instrument can permanently memorise the latest operations
which are considered as last data entered.
So the following information is maintained
A)
measurement unit selected (MM/INCH/DEG).
B)
function settings entered.
C)
last Axis counting position and eventual messages (not
transitory) concerning abnormal situations, e.g. overflow
message.
IMPORTANT NOTE:
When there is a power failure, the instrument cannot register any scale
movement (through inertia, manual movements, thermal expansion) whether in
ABS or INC. If this happens, the data on the display is not reliable because it
cannot indicate new positions but only those previous to the power failure.
SETTING CONFIGURATION
For the configuration of the device some internal parameters have to be used.
To recall the configuration, push the button P, enter the password number and
confirm by button SET. The selection of parameter is made by repeatedly
pressing button P.
Important notes :
1) To access parameters section, it is necessary to enter a 6-digit
password (manufacturer code: “000000”). It is possible to change this
code.
2) During the parameter setting, the display will show “P”.
Parameters currently entered are the following:
Parameter 01
– CHOICE OF AXIS RESOLUTION
Parameter 02
– INVERSION OF COUNTING MODE
Parameter 03
– LINEAR CORRECTION
Parameter 04
– ENABLE AND SET THE REF VALUE OF INCREMENTAL
QUOTA
Parameter 05
– ENABLE AND SET THE REF VALUE OF ABSOLUTE
QUOTA
Parameter 06
– ENABLE AND SET TIME FOR DEVICE SELF-SWITCH.
OFF
Parameter 07
– ENABLE RESET/PRESET INCREMENTAL QUOTA
Parameter 08
- ENABLE RESET/PRESET ABSOLUTE QUOTA
Parameter 09
– ENABLE AND SET TIME FOR STAND-BY OF DISPLAY
Parameter 10
– SET FACTOR OF FREE CALCULATION
Parameter 80
– MODIFY PASSWORD TO ENTER PARAMETERS
Parameter 89
– DEVICE DIAGNOSTIC
Parameter 90
– RESERVED
Содержание VISION 110L
Страница 29: ...22 06 2010 MT04_A30_B_VI110L_GIVI_ENG REV B 29 32 SPECIAL FUNCTIONS ON CUSTOMER S REQUEST...
Страница 30: ...22 06 2010 MT04_A30_B_VI110L_GIVI_ENG REV B 30 32...
Страница 31: ...22 06 2010 MT04_A30_B_VI110L_GIVI_ENG REV B 31 32...
Страница 32: ...22 06 2010 MT04_A30_B_VI110L_GIVI_ENG REV B 32 32...
