7
Swiss Lifting Solutions
This instruction manual was issued in 2019. It corresponds to directive 2006/42/EC of the European Parliament and council of 17 May
2006 (including its amendments). The LP models are calculated for the case of operation with a shock factor of 1.4 (per DIN EN 818-7 with
max. 8 m/min.). The accidents audited by the laboratory generate smaller shock factors than the normal mode.
0.5 Technical status
When working in a noisy environment, the use of ear protection is recommended.
Measuring distance
1 m
2 m
4 m
8 m
16 m
Series
Measurement type
dBA
LPM 250, LPML 250
a
b
65
65
62
59
59
53
56
47
53
41
LP 500, LPL 500
a
b
60
60
57
54
54
48
51
42
48
36
LP 500 1Ph, LPM 250 1Ph
a
b
76
76
73
70
70
64
67
58
64
52
LP 1000, LP 1000 1Ph
a
b
75
75
72
69
69
63
66
57
63
51
LP 1600/2500
a
b
75
75
72
69
69
63
66
57
63
51
Table 0-1 Sound pressure level
0.4.3 Sound pressure level
Tests on the chain hoist sound level are performed at a range of 1, 2, 4, 8 and 16 metres from the centre of the electric chain hoist motor to
the measuring device. Measurement of SPL per DIN 45 635.
The sound pressure level was measured:
a) During operation of electric chain hoists on factory site.
b) During open-air operation of electric chain hoists.
Physical injury:
Death from electrical shock, injury and burns through:
• contact
• faulty insulation
• faulty maintenance or repair work
• short circuit
Causes:
• contact with, touching or standing too close to uninsulated power and live parts
• use of uninsulated tools
• exposed electricity supply terminals following insulation failure
• inadequate safety checks following repair work
• incorrect fusing
Safety options:
• Isolate machinery and equipment designated for repair or maintenance work before commencing such work.
• First check isolated parts for voltage.
• Regularly check electrical fittings.
• Replace loose or damaged cables immediately.
• Always replace blown fuses with fuses of the correct type/value.
• Avoid contact with or touching live terminals.
• Only use insulated tools.
0.4.2 Hazards - Electrical
Work on electrical apparatus or machinery may only be performed by qualified electricians or persons under the supervision and guidance
of qualified electricians, in accordance with electrical regulations.
Содержание LP 1000
Страница 1: ...01 20 Translation 9500 9003 1 TRANSLATION OF THE ORIGINAL INSTRUCTION MANUAL ELECTRIC CHAIN HOIST LP ...
Страница 2: ......
Страница 32: ......