Gis LP 1000, Перевод оригинального руководства пользователя

Страница: 10 / 32

10 Swiss Lifting Solutions
The manufacturer will only guarantee the safety and lasting operation of the electric chain hoist when used for applications in accordance
with valid standard values that fall within its classification.
Before the initial start-up, the user must estimate according to the parameters in table 1-1, which of the four types of load is applicable to
the use of the electric chain hoist during its whole life cycle. The table 1-2 shows standard values for the operating conditions of the classi-
fications depending on the type of load and time of operation.
Classification according to application requirements:
Electric chain hoists and trolleys are categorised in accordance with the following regulations into classifications:
• DIN EN 14492-2 (A5 = 125,000 cycles)
• ISO 4301-1 (M5 = 1 600 h)
• DIN 15401 / DIN EN 13001 (load hook)
• Remarks about general overhaul (see chapter 4)
There is different coefficient data for the classifications that must be adhered to in operation.
The travel trolley must have at least the same lifting capacity as the electric chain hoist.
The classification of the electric chain hoist can be found on the data plate.
1.1 Operating conditions
The LP series includes the following models: LPM, LPML, LP, LPL.
1 Description
0.6.1 Use of the instruction manual
This instruction manual includes the following chapters:
0 General information 3 Care and maintenance
1 Description 4 Measures for achieving safe operating periods
2 Start-up 5 Appendix
Supplementary to the instruction manual, the following documentation from the operator must be noted:
• Declaration of conformity
• Inspection pass
• Spare parts list(s)
• Circuit diagrams
Page and figure numbering:
The pages are consecutively numbered. Blank pages are not numbered, however are calculated together with the consecutive pages.
Figures are numbered consecutively by chapter. Example: Figure 3-1 means: in chapter 3, figure 1.