Gis LP 1000, Перевод оригинального руководства пользователя

Страница: 16 / 32

1
3
2
16 Swiss Lifting Solutions
Figure 2-7 Figure 2-8 Figure 2-9
Chain end:
The chain end is to be fixed to the housing in accordance with figure 2-7 or figure 2-8 and the limit stop in accordance with figure 2-9.
Ensure that the end of the chain is not twisted. The section of chain after the limit stop (1) must be adjusted to the height of the chain
container. Here, the length of the chain section must be selected such that the limit stop lies on the floor of the container when the chain is
pulled into it (see figure 2-10).
1 fall operation:
The load hook (1) is connected to the chain with a single fall hook clamp (2). For the power transmission, the mounting of the bolt (3) is
important (see figure 2-11).
• Note correct arrangement of suspension (mass k1, see figure 2-12 or for LP 2500, see figure 2-13):
LPM/LPML 250 = symmetrical, LP/LPL 500 = 41 mm, LP 1000 = 43 mm, LP 1600 = 53 mm, LP 2500 = 87 mm.
• Grease the bearings thoroughly (load hook).
Figure 2-6
2.2.3 Load chain
• Only use original chains.
• Welding seam of the chain links must face inward on the chain wheel (see figure 2-6).
• When used as a climbing hoist, make sure that the entry and the run-out of the chain is not prevented
by chain clusters.
• The geared limit switch must be mechanically deactivated for pulling in the chain, see chapter 2.2.4.
Before start-up and during operation, the load chain must be oiled along its full length. Oil must constantly be present on the internal, con-
tacting and rubbing surfaces of the chain links. Lubrication is carried out by submersion or with an oil can, using a creeping gear oil. The
end of the chain (1) should be attached to a flexible piece of wire or chain pulling loop (2) and fed through the chain wheel (3) of the electric
chain hoist. Through short switching impulses, the chain will be pulled in correctly in accordance with figure 2-6. The lifting height must be
adjusted such that the hook fittings lie on the ground in the lowest hook position.