Page 6 of 14
If the awning extends at this point instead of retracting, press the STOP button
immediately, then remove the power supply to the motor controller for at least 10
seconds.
Next repeat steps 1 and 2 above then press the OUT button on the wall switch to
complete the programming procedure.
Ensure that the awning responds correctly to the wall switch by pressing the OUT,
STOP and IN buttons alternately.
GC661B MULTI CHANNEL WALL SWITCH
The faceplate can be removed easily by holding the module firmly in one hand at the
left and right edges and push on the faceplate below the display screen with two
fingers of your other hand. Fig.1 below shows how the batteries must be inserted.
Close the battery tray and replace the faceplate, you will find the pushbuttons clearly
marked. See Fig.2 below.
Fig.1
Fig.2
When pairing with the GC1146C it is advised that the awning to be controlled is
manually extended couple of feet to enable the programmer to see if the awning is
responding in the correct direction when the buttons on the wall switch are pressed.
The programming window for this module is only 10 seconds so please
ensure that the programming instructions are read and understood before
attempting to execute them.
