Page 7 of 14
First determine which channel of the wall switch is to be paired with the motor
controller, then;
1)
Select the desired channel on the wall switch using the CH button.
2)
Supply power to the motor control module. (It will beep ONCE )
3)
Press the P2 button on the wall switch TWICE. (The motor controller will beep
with each press)
4)
Press the IN button on the wall switch. (The awning should retract)
If the awning extends at this point instead of retracting, press the STOP button
immediately, then remove the power supply to the motor controller for at least 10
seconds.
Next repeat steps 1 and 2 above then press the OUT button on the wall switch to
complete the programming procedure.
Ensure that the awning responds correctly to the wall switch by pressing the OUT,
STOP and IN buttons alternately.
