Page 14 of 14
Note; when carrying out this part of the procedure each step must be
executed within 6 seconds of the previous one or the module will revert to
factory settings. It is highly recommended that you read and understand the
following sequence before attempting to execute it.
1)
Set the Motion sensor Adjustment Dial to 0. (See Fig.4).
2)
Connect the GC779G Motion sensor to a 12volt DC circuit. At this point the
Purple LED will illuminate and then begin to blink. If it does not, the unit is not
receiving the correct power. Ensure that the magnet and reed switch are aligned
and verify the electrical connection before proceeding.
3)
Using an appropriate tool, press the P2 Button on the back of the Remote
Controller TWICE. The GC1146C will bleep ONCE with each press.
4)
Press the programming button on the GC779G Motion sensor ONCE (See Fig.4).
The GC1146C will bleep several times to indicate that the program has been
accepted.
5)
Ensure that the code was accepted by pressing the Program button on the
GC779G Motion sensor again. The Awning should make a small step IN or OUT.
Or shake the motion sensor and the Awning will fully retract.
6)
If the Awning does not retract, repeat steps a. to d.
7)
Set the Adjustment Dial to the desired sensitivity level 1 to 5. Never set higher
than 5. (The factory setting is 3).
Once programming is complete, reassemble the Motion sensor module and mount it on
the awning lead rail.
For queries or assistance with programming any of your G-Link devices
please call Girard Systems TOLL FREE on 800–382–8442 between 7:30am
and 3:30pm P.S.T.
