Page 11 of 14
PAIRING WITH A GC116I ANEMOMETER
Fig.1
•
Fully extend the awning to ensure smooth operation, then retract the awning
leaving it partially open (about 3 feet).
•
Locate the P2 Button on the back of the Primary remote.
•
Set the wind speed dial between 1 and 2 on the anemometer. See Fig.1 above.
Note; when carrying out this part of the procedure each step must be
executed within 6 seconds of the previous one or the module will revert to
factory settings. It is highly recommended that you read and understand the
following sequence before attempting to execute it.
1)
Connect the Anemometer to a 12V DC Power source. (The Red LED will flash
once when power is connected)
2)
Press the P2 button on the back of the Primary remote TWICE (The Motor
controller will beep with each press)
3)
Press the P2 button on the Anemometer ONCE (The motor controller will beep
several times to indicate that the program has been accepted)
4)
Press the up button on the Anemometer or physically activate it by spinning the
cups to retract the awning.
Wind Speed Dial
P2 Button
UP Button
LED
