INSTALLATION
Take the Analogue Click Clock and wall plug adapter out from the package and place it in a safe place.
Please connect the wall plug adapter to the DC point at right bottom on the back of the clock to to power the clock
and charge the in-built back-up rechargeable battery at the same time.
The LED charging light next to the DC point should indicate red when charging and green when it is fully charged.
Hold down the power button
at the back for 3-5 seconds to turn on the clock, the LED dots display should
instantly light up on the front face of the clock.
You may remove the plug adapter once it’s fully rechargeable, but the battery will only last approx 2 days when the
clock is in permanent display or approx 12-15 days in sound activated display.
It’s advised to have the clock plugged in all the time as the in-built rechargeable battery is more used for a back up
power if there is any power cut situation. It’s safe to do this as the charging will be automatically disconnected
when the in-built battery is fully charged.
The Analogue Click Clock can also be wall mounted if required.
OPERATING BUTTONS INTRUCTION
SET
: to access to the time setting mode
+ : to scroll up the hour or minute when in setting mode; holding it down in display mode will activate or deactivate the
second dot display on analog display screen.
-
: to scroll down the hour or minute when in setting mode.
: alarm setting button, to access to the alarm setting mode
: Power switch, to turn on or turn off the clock
DISPLAY SCREEN INTRODUCTION:
The short hand represents the hour hand and the long hand represents the minute hand. The 12 dots circle represents
the analogue face. Please see below as examples of different time display on the Analogue Click Clock.
12:13 AM/PM
2:00 AM/PM
4:58 AM/PM
Содержание Click Clock Analogue
Страница 1: ......