4. Using a Phillips #1 screwdriver, install the screws that secure the cable cover to the
system.
After installing the right control panel you could do the following:
1. Install the internal PERC riser.
2. Follow the procedure listed in
After working inside your system
.
System Board
Removing the System Board
CAUTION
: If you are using the Trusted Platform Module (TPM) with an encryption key,
you may be prompted to create a recovery key during program or System Setup. Be
sure to create and safely store this recovery key. If you replace this system board, you
must supply the recovery key when you restart your system or program before you
can access the encrypted data on your hard drives.
CAUTION:
Do not attempt to remove the TPM plug-in module from the system board.
Once the TPM plug-in module is installed, it is cryptographically bound to that specific
system board. Any attempt to remove an installed TPM plug-in module breaks the
cryptographic binding, and it cannot be re-installed or installed on another system
board.
l
Follow the safety guidelines listed in
l
Follow the procedure listed in
Before working inside your system
l
Remove the following:
• Air shroud
• All expansion cards and risers
• Internal PERC riser
• IDSDM/vFlash module card
• Internal USB key (if installed)
Contents
84
GigaVUE-FM Hardware Appliance Guide for GFM-HW1-FM010
