1. Unpack the new power supply unit (PSU).
2. Slide the new PSU into the PSU cage until the PSU is fully seated.
3. Using a Phillips #2 screwdriver, replace the screw to secure the PSU to the system.
After installing you do the following:
1. Connect the PSU cables to the connectors on the system board.
2. If applicable, install the expansion card riser.
3. Install the air shroud.
4. Follow the procedure listed in
After working inside your system
Power interposer board
Removing power interposer board
l
Follow the safety guidelines listed in
l
Follow the procedure listed in
Before working inside your system
l
Remove the air shroud
l
Disconnect all the cables connected from the PIB to the system board.
N
OTE
:
Ensure that you note the routing of the cables as you remove them from
the system board.
l
Remove the PSU.
Follow the below steps to remove the Interposer Board:
1. Using a Phillips #2 screwdriver, remove the two screws securing the Power Interposer
Board (PIB) to the system.
Contents
79
GigaVUE-FM Hardware Appliance Guide for GFM-HW1-FM010
