4. Slide the LOM riser card towards the front of the system until the Ethernet connectors
or the Small form-factor pluggable (SFP) are clear of the slot in the back of the system.
After removing the LOM riser card you could do the following:
l
Install the LOM riser card.
Installing the LOM riser card
l
Follow the safety guidelines listed in
Follow the below steps to install the LOM riser card:
1. Align the connectors on the LOM riser card with the slot on the system.
2. Press the LOM riser card until the card is firmly seated on the system board connector
and the two blue plastic snap hold the LOM riser card in place.
3. Using a Phillips #2 screwdriver, replace the screws to secure the LOM riser card to the
system board.
After installing the LOM riser card you could do the following:
l
If removed, install the risers.
l
Follow the procedure listed in
After working inside your system.
Contents
67
GigaVUE-FM Hardware Appliance Guide for GFM-HW1-FM010
