GIESSE 07888, Инструкция по установке и эксплуатации

Страница: 19 / 64

19
2.2. Maximum opening according to height of sash
The actuator stroke is in accordance with the height of the sash and its application. Check that the actuator stroke does not touch
the profile of the sash and that the chain does not exert force on the window frame (measurements in mm).
A
TTENTION
. For safety reasons the actuator should not be assembled if dimensions are inferior to those indicated in the table
below. In the event that the height of the sash should be lower, call on the manufacturer to check the appliance.
Mode of installation
Selection of actuator stroke
100 200 300 400
Light domes, skylights or vertical top hung
windows opening outwards with frontal assembly
150 250 350 450
Top hung windows opening outwards with
horizontal assembly
150 250 350 450
Bottom hung windows (motor on frame) 250 450 600 700
Bottom hung windows (motor on sash) Consult manufacturer
3. Technical information about function
The chain operated actuator opens and closes windows by means of a steel chain located inside the cover. Movement is
powered by electricity which powers a gear motor controlled by an electronic function device. Window opening can be
programmed to open at 100, 200, 300 and 400 mm
(see respective chapter) .
During closure the end course uses a self-regulating electronic process with power absorption and therefore requires no
regulation.
The actuator leaves the factory with factory settings of +1 cm for the return course which allows the actuator to be assembled
without electricity, with the window in closed position after assembly is complete.
4. Manufacture and reference standards
INTENDED USE. The VARIA SLIM RADIO chain actuator is designed and built to open and close awning and bottom-
hung windows, dormer windows, domes and skylights used for ventilation and climate control in rooms; any other use is
strongly discouraged, with the supplier of the entire system in any case retaining sole liability. It can also be used in
combination with the
SPR / SPR RADIO operated rain sensors.
The actuator is manufactured in accordance with the Directives and following Regulations listed in the attached
Declaration of Incorporation and Conformity
.
Electrical connections must conform to regulations in force for the design and set up of electrical equipment.
To ensure efficient separation from the grid, an
approved type of bipolar “dead-man” switch should be used. An omnipolar
general power switch with minimum distance of 3 mm between contacts should be installed upstream of the control line.
The VARIA SLIM RADIO actuator is packed in one single carton. Each package contains:
•
Actuator with 2 metre (±5%) lead.
•
Standard support brackets with distancer (A).
•
Bracket for vertical assembly of the actuator (B).
•
Bracket for transom window (C).
•
Bracket for outward opening fixture (D).
•
Template for boring.
•
Instruction manual.
5. Technical data
MODEL VARIA SLIM RADIO
Force exerted by thrust and traction (F
N
) 300N
Strokes (S
V
) 100, 200, 300, 400 mm
Power supply voltage (U
N
) 110-230V~ 50/60 Hz
Rated absorbed current (I
N
) 0,31A - 0,24A
Current consumption with no charge 0,084A - 0,042A
Charge absorbed at nominal load (P
N
) 23-27W
No load speed 15,7 mm/s
No load duration (400 mm) 25 s
Electrical insulation Class II
Type of service (D
R
) 2 cycles
Working temperature - 5 + 65 ºC
Protection index IPX0
Adjustment of socket at casing Autopositioning
Holding nominal force (it can vary according to the chosen brackets) 1600 N
Connection of two or more devices in parallel YES
Limit switch stop at opening Electronic by means of dip-switches
Limit switch stop at closure At absorption of charge
Dimensions 386,5x59x37
Weight 1,000 kg
Any information reported in this table is not binding and may be susceptible to variations without notice