+GF+ SG 160, Инструкция по эксплуатации

Страница: 17 / 60

Operating instructions SG 160 7 Fusion Preparation
13
7 Fusion Preparation
7.1 General information
This manual is based according to the instruction sheets and guidelines issued
by the DVS.
The fusion area should be protected against the influences of weather
(humidity, ambient temperature <+ 5 °C, extreme dir ect exposure to sun) with
such measures as pre-warming the fusion materials, tents, heating.
For optimal use of the SG 160, operating personnel must be specially trained
by Georg Fischer. In-depth knowledge of the machine and the related
components rule out handling errors, thereby also preventing faulty fusion
joints.
7.2 Heating element settings
7.2.1 Temperature setpoint adjustment
To set the welding temperature, press the button P shortly < 3 sec.
The LED OUT 1 will switch ON, the actual temperature set point for the
welding temperature is displayed.
By pressing UP or DOWN the desired temperature set point can be selected.
Press shortly UP or DOWN to change one unit only, by pressing continuosly
the UP or DOWN button the digits will change fast.
To confirm the new setting press the button P shortly < 3 sec or wait
approximately 15 seconds to change automatically in the operation mode.
The current measured temperature will be displayed. When the temperature is
at the set point the green LED will be on, if the temperature is below the set
point the LED OUT 1 will be on!
2 1 0 2 1 0 2 1 0 2 1 0
P
U
▼
▲
2 6 0 2 6 0 2 6 0 2 6 0
P
U
▼
▲