28
Equipment that is not too heavy may be
supported by a second person.
For heavy equipment use suitable lifting
equipment of sufficient strength.
Detach the end connections of the equipment
from the pipes.
Put the equipment onto a suitable base.
Store the equipment as described in section
"Storing the equipment"
on page 8.
Re-using equipment after storage
Observe the following instructions if you want to
remove the equipment and use it again somewhere
else:
Make sure that the equipment is free of any
fluid residues.
Make sure that all connections are in good
condition and leak-free.
If necessary re-work welded connections in
order to ensure that they are in good working
condition.
Use the equipment only for its intended purpose
and the service conditions for which it was
specified.
Disposing of equipment
Attention!
Environmental damage may be caused by
poisonous fluid residues.
Before disposing of the equipment
make sure that it is clean and free of
fluid residues.
For the disposal of all materials
observe the pertinent legal regulations
concerning waste disposal.
The equipment is made from the following
materials:
Component
EN
ASTM
Body
1.0460
A 105
Cover
Body screws
1.7225
A 193 B7
Thermovit regulator
Stainless steel
Body gasket
Graphite / CrNi
External setting
device BW31
CW 612 N
–
Seal ring for external
setting device BW31
EPDM
Gasket for external
setting device BW31
and BW 31A
1.4301 N
–
External setting
device BW31A
1.4571
AISI 316 Ti
Stuffing box BW31A
Graphite
