4
Setup & Suggestions
•
Locate the press on a firm, sturdy work surface.
•
The height of the bench/work space the press is located on would be
ideally 27” to 32” high.
•
Attach the power cord from the rear to the underside of the top head.
•
There is a power inlet under the top head that the modular cord will
plug into.
•
Make sure the cord does not interfere with the lower table pressing
area, or the height sensor.
•
The press should remain in the unclamped position when not in use.
Do not leave the heater block closed on the table surface when hot if
not using.
•
The top head should be swung over and above the pressing table when
not in use.
Basic Use
Setting Time
The time setting is always editable in the default operating mode
of the controller. The left two digits of the time display are minutes.
The right two digits are seconds. This can be changed to Hours/
Minutes in the User Options Menu.
•
Use the Up & Down arrow keys to change the time.
•
Hold the Up or Down arrow key down to increment the values quickly.
After a brief pause, the values will accelerate.
•
Press the Up & Down arrow keys together to clear the setting to 00:00
•
When the press is closed, the timing cycle starts. The “TIMING”
indicator will appear.
•
When the timing cycle is finished, the “DONE” indicator will appear.
•
Depending on the timer alarm chosen, the alarm may continue to sound
at the end of the timing cycle until the press is opened.
•
When the press is opened up, the “OPEN” indicator will appear.
