5
4. DATA LOGGER
3. OPERATION
Genvex item no. 022031
– USB/Optima communication cable for PC
Data logging equipment
There are two ways to adjust set points and program the
Optima 260 control system.
1. Programming via Genvex Genlog software using a USB
connected to the Optima 260 main circuit board.
2. Programming via Genvex Genlog software and
outputting set points to the SD card. (Use the "save to
SD card" function in the Set Point Management menu.)
Note on method 1
To be able to initiate communication with Optima 260,
use data logger equipment with a 4-pin connector.
Connect the 4-pin connector to the main circuit board
and the USB connector to the PC. These are accessories
that can be purchased directly from Genvex.
Note on method 2
To use method 2 to initialise a Genvex unit with an
Optima 260 control system, we recommend that you
remove the SD card of the main circuit board again after
starting up the unit (start-up and input of data take
approx. 2 minutes) as Optima 260 will input the
preprogrammed data on the SD card every time there
is a power outage. You can replace with advantage the
programming SD card with an empty SD card in order to
take advantage of the automatic data logging feature.
The latest version of the Genvex Genlog software can be
ordered from Genvex by tel45 73532700.
1
2
3
4
K3 K5
All Genvex ventilation units with Optima 260 control
system can be operated with an Optima 100 display.
The Optima 100 control system has the following
setup options:
• Fan speed
• Filter alarm
• Reheater activation/deactivation
The control system comes factory-preset, which means that
the unit can be put into operation without changing
the operating settings. The factory setting is only a basic
setting that can be adapted to the operating desires and
demands for the dwelling in question to make it possible to
achieve optimal utilisation and operation for the system.
3.1 Operating and Changing Settings
Optima 100 Design is operated with the K3 and K5 keys.
Optima 100 Opus is operated with the K3 and K5 keys.
The K3 key is used to change fan speed. To turn off the
ventilation unit, press and hold the K3 key for approx.
5 seconds (the unit will shut down after an afterflow period
of approx. 3 minutes).
Note: the "turn off ventilation" feature must first be
enabled in the control system via Genlog.
The K5 key is used to reset the filter alarm (press and hold
for 10 seconds). Individual push of the key activates/
deactivates a possible electric reheater, if mounted.
