Genie Z-45J, Руководство оператора

Страница: 45 / 74

Fifth Edition • First Printing
Operator's Manual
Inspections
Part No. 1297032GT Z
®
-
45J DC • Z
®
-45J Bi-Energy 43
53 Return to level ground and stow the boom.
54 With the boom fully stowed, drive the machine
onto a slope where the chassis pitch angle is
greater than 2.5°.
Result: The machine should continue to drive.
55 Return to level ground and raise the
secondary boom to an out of stowed position
(approximately 15° above horizontal).
Result: The machine should stop once the
machine reaches 2.5° of chassis tilt and the
alarm should sound at the platform controls.
56 Lower the secondary boom to the stowed
position or drive in the opposite direction.
Result: The machine should drive.
57 With the boom fully stowed, drive the machine
onto a slope where the chassis pitch angle is
greater than 2.5°.
Result: The machine should continue to drive.
58 Return to level ground and raise the primary
boom to an out of stowed position
(approximately 10° above horizontal).
59 Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
60 Lower the primary boom to the stowed position
or drive in the opposite direction.
Result: The machine should drive.
61 Return to level ground and extend the primary
boom approximately 1.6 ft / 0.5 m.
62 Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
63 Retract the primary boom to the stowed
position.
Result: The machine should drive.
64 Return to level ground and stow the boom.
65 With the boom fully stowed, drive the machine
onto a slope where the chassis roll angle is
greater than 4.5°.
Result: The machine should continue to drive.
66 Return to level ground and raise the
secondary boom to an out of stowed position
(approximately 15° above horizontal).
67 Drive the machine onto a slope where the
chassis roll angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
68 Lower the primary boom to the stowed
position.
Result: The machine should drive.