Genie Z-45 XC, Руководство по обслуживанию

Страница: 60 / 440

4 - 30 Genie Z-45/25 & Genie Z-45/25J Part No. 52709
First Edition • Second Printing Section 4 • Scheduled Maintenance Procedures
TABLE B PROCEDURES
5 Open the ground controls side turntable cover.
6 Inspect the following areas for burnt, chafed,
corroded and loose wires:
· Inside of the ground control box
· Hydraulic manifold wiring
7 Start the engine from the ground controls and
raise the boom above the turntable covers.
8 Inspect the turntable area for burnt, chafed and
pinched cables.
9 Lower the boom to the stowed position and turn
the engine off.
10 Inspect the following areas for burnt, chafed,
corroded, pinched and loose wires:
· Cable track on the primary boom
· Cables on the primary, and jib booms
· Jib boom/Platform rotate manifold
· Inside of the platform control box
11 Swing the engine back to its original position
and close the engine pivot plate latch.
12 Install the engine pivot plate safety pin
(if equipped).
B-3
Check the Radiator -
Ford Models
Maintaining the radiator in good condition is
essential for good engine performance. Operating
a machine with a damaged or leaking radiator may
result in engine damage. Also, restricting air flow
through the radiator (i.e., dirt or debris) will affect
the performance of the cooling system. A frequent
check allows the inspector to identify changes in
the condition of the radiator that might indicate
cooling system problems.
Bodily injury hazard. Do not
inspect while the engine
is running. Remove the key to
secure from operation.
Burn hazard. Beware of hot
engine parts and coolant. Contact
with hot engine parts and/or
coolant may result in severe
burns.
1 Remove the safety pin (if equipped) from the
engine pivot plate latch.
The engine pivot plate latch is
located under the engine turntable
pivot plate at the counterweight
end of the machine.