Genie Z-45 XC, Руководство по обслуживанию

Страница: 103 / 440

Part No. 52709 Genie Z-45/25 & Genie Z-45/25J 4 - 73
First Edition • Second Printing Section 4 • Scheduled Maintenance Procedures
TABLE E PROCEDURES
13 Swing the engine back to its original position
and close the engine pivot plate latch.
14 Install the engine pivot plate safety pin
(if equipped).
15 Start the engine from the ground controls,
run it for 30 seconds, and then turn it off.
16 Inspect for leaks and then check the fluid
level in the coolant return tank. Add
water if needed.
17 Start the engine from the ground controls
and let it run until it reaches normal operating
temperature.
18 Turn the engine off.
19 Allow engine to cool and check the fluid level in
the coolant retrun tank. Add water if needed.
Coolant capacity 11.5 quarts
10.9 liters
4 Disconnect the coolant return hose at the
radiator and drain the coolant return tank into a
suitable container.
5 Slowly remove the radiator cap from the
radiator.
Bodily injury hazard. Allow any
pressure to dissipate gradually
before removing the radiator cap.
6 Open the drain valve on the radiator and allow
all the coolant to drain into a suitable container.
7 After all the coolant has drained, close the drain
valve. Connect the coolant return hose to
the radiator.
8 Open the drain valve on the engine block and
allow the coolant to drain into a container.
After the fluid is drained, close the drain valve.
9 Replace all coolant hoses and clamps.
10 Pour the proper coolant mixture (anti-freeze and
water) for your climate into the radiator until it is
full.
11 Fill the radiator and then fill the coolant return
tank to the
NORMAL
range.
12 Clean up any coolant spilled during this
procedure.