Genesis LXP 200, Инструкция по безопасности и эксплуатации

Страница: 27 / 83

26 Genesis LXP
®
© 2015 Genesis Attachments, LLC
MAINTENANCE
BOLT TORQUE SPECIFICATIONS
Genesis typically uses dry torque measurements, but there are exceptions, such as piercing tip
bolts, which are lubricated.
Prior to using the chart below, clean all bolt holes, bolts and nuts to remove dirt, grease and oil.
See following Visual Reference charts or Parts Lists to identify bolt type.
Never retorque bolts that use Loctite. After initial use, when Loctite was applied and bolt was
torqued, if the bolt becomes loose or damaged, it must be replaced.
Never break tightened bolts loose with a torque wrench. Doing so may break the torque wrench
or take it out of calibration.
Torque wrenches should be calibrated on an annual basis.
When using a torque multiplier with a torque wrench, incorrect settings will be multiplied by the
ratio of the torque wrench.
Never use an air wrench on a torque multiplier.
Fastener Grade Size x Pitch Nm Ft-lb
CL 10.9
M8 x 1.25 36.5 27
M10 x 1.50 72 53
M12 x 1.75 125 92
M14 x 1.50 210 154
M14 x 2.00 200 148
M16 x 2.00 313 230
M20 x 1.50 640 472
M20 x 2.50 610 450
M24 x 3.00 1055 778
M27 x 3.00 1543 1138
M30 x 3.50 2095 1545
8
1/2-13 145 107
1/2-20 163 120
5/8-11 286 211
3/4-10 510 376
7/8-9 822 606
1.00-8 1220 900
1.00-14 1345 992
1.50-6 4280 3160
L9 1.00-8 1152 850
9 1.25-7 2464 1817
Fastener Grade Size x Pitch Nm Ft-lb
CL 10.9
M20 x 2.50 458 338
M27 x 3.00 1157 850
M30 x 3.50 1572 1160
8
3/4-10 383 282
7/8-9 617 455
1.00-8 916 675
1.25-7 1847 1362
9 1.50-12 4067 3000
Dry Torque Values Wet Torque Values
Grease or anti-seize on threads and under bolt threads