GENERGY 401173, Инструкция по эксплуатации

Страница: 71 / 150

68
Englis
h
6 Pull the startup handle slowly and until the end to calculate the maximum length
of the rope (and do not exceed it later when pulling vigorously), then allow the rope
to coil back.
Pull softly again until you notice slight resistance, now allow the rope to coil back
and pull vigorously to start up the engine.
NOTE:
If you reach the end of the rope length abruptly you could damage the
handle or rope spring and it wouldn't be covered by warranty.
Do not let go of the handle after pulling to prevent the handle from hitting the
machine. Move your hand along with the handle until it has coiled back completely.
7
Once started, the lamp in panel pass to green color, and then slowly turn the
choke completely to the right side (RUNNING) according figure below.
.
NOTE:
Do not leave the choke in an intermediate position, the blend would
be too rich and the engine would not work properly.
8 After starting, allow generator to run at no load for few minutes upon each initial
start-up to permit engine stabilize and increase its temperature softly, then you can
connect the loads.