BCT_T Rev.00 05-2015
pag. 112
Operate as indicated to stop the cycle:
6.
Press and hold the START/STOP key 3 s.
When the temperature detected by the needle probe reaches the blast chilling end temperature, it means that blast
chilling has been completed and the device will automatically pass to maintenance.
During maintenance the the blast chilling end temperature also establishes the work set-point during maintenance.
On expiry of the duration of maintenance the device automatically passes to storage.
Parameter r11 establishes the work set-point during storage.
7.7
– OTHER FUNCIONS
7.7.1
– MEMORISATION OF A PROGRAM
Operate as follows:
1.
Make sure that the keyboard is not locked and that no procedure is in progress.
2.
Press and release the
key (1) before starting an operating cycle or during storage: the device will display the
number of the first program available.
2.1
If the
key is pressed and released before starting an operation cycle, the device will memorise the following
settings:
-
type of operating cycle selected
-
blast chilling/deep freezing intensity selected
-
if the key is pressed before starting-up a temperature-controlled cycle:
-
the work set-point during blast chilling and the blast chilling end temperature
-
if the key is pressed before starting-up a time-controlled cycle:
-
the work set-point during blast chilling and the blast chilling duration.
2.2
If the
key is pressed and released during storage, the device memorises the following settings:
-
type of operating cycle in progress
-
the duration of blast chilling or deep freezing, i.e. the time taken to successfully complete blast chilling or
deep freezing.
-
blast chilling/deep freezing intensity selected before starting an operating cycle.
-
the work set-point selected before starting up an operating cycle.
The execution of a program memorised by pressing and releasing the
key during storage causes the start of
a timed cycle.
Содержание New Runner Series
