13
www.geiger.de
EN
EN
14. Deactivating the obstacle detection in DOWN direction
With Easy-ZIP, the obstacle detection is deactivated with following sequence:
Then move the sun protection in DOWN direction otherwise the modification will not be accepted.
The motor jerks 1 x for confirmation.
15. Reactivating the obstacle detection
The obstacle detection is active again as soon as the motor is switched into the learning mode for
end positions.
16. End position correction
If a
lengthening/shortening
of the hanging has resulted due to e.g. temperature changes, this
will be automatically corrected by closing the awning.
If, due to temperature changes,
modified winding behaviour
should arise and the hangings
should run against the stop, an immediate end position correction takes place.
After the first reference run, the motor automatically identifies the torque necessary to close the
screen and closes it with the lowest possible power, so that the fabric is optimally protected.
17. What to do if…
Problem
Solution
Motor does not run.
• Motor not plugged in.
Please check the plug connection.
• Check connecting cable for possible
damage.
• Check the mains voltage and allow the
cause of the voltage break down to be
tested by a specialist
electrician.
Instead of in the upwards direction, motor
runs downwards.
• The control leads are interchanged.
Exchange black/brown control leads.
Motor only runs in one
direction.
• Motor in the end position.
Run motor in the opposite direction.
Re-adjust the end positions, if necessary.
After running several times,
the motor breaks down and
no longer responds.
• The motor became too hot and has
switched off.
Try it again after a cooling time of about
15 min.
18. Maintenance
The drive is maintenance-free.
5 sec.
1 sec.
5 sec.
1 sec.
5 sec.
1 sec.
1 sec.
break
UP
–
–
–
–
–
–
break
UP
break
5 sec.
–
break
5 sec.
–
break
DOWN
UP
