11
www.geiger.de
EN
EN
11. Setting of the end positions with Easy-ZIP 2.x
(Qi mode)
I
The distance between the upper and lower end stops must be about
25 cm which corresponds to one tube rotation at least.
Programming the end positions
1.
Connect the connecting cable of the motor to the control switch.
2.
To open the learning mode for end positions, press the PROG key or the UP and DOWN
keys simultaneously until the motor confirms (1 x clac-clac). The motor jerks (start, stop,
start) at each run command to confirm the learning mode activation.
3.
Move the screen to the required lower end position. Any adjustment can be realized here.
4.
Move the screen to the upper position without any interruptions until the motor shuts down.
(torque detection). The programming procedure is then completed and the motor returns to
normal operating mode.
Motor feedback
Easy-ZIP 2.x
1 x click-click
• Learning mode for end positions activated
12. Setting of the end positions with Easy-ZIP 3.x
(automatic mode)
I
The distance between the upper and lower end stops must be about
25 cm which corresponds to one tube rotation at least.
Programming the end positions
1.
To open the learning mode for end positions, press the PROG key or the UP and DOWN
keys simultaneously until the motor confirms (1 x clac-clac). The motor jerks (start, stop,
start) at each run command to confirm the learning mode activation.
2.
Keep UP or DOWN keys pressed to move the screen to the required lower end position until
the motor automatically shuts down (torque shutoff).
3.
Keep keys pressed
4.
The screen moves now automatically to the upper end position. When the screen has
reached the upper position the motor shuts off. The programming procedure is then
completed and the motor returns to normal operating mode.
Motor feedback
Easy-ZIP 3.x
1 x click-click
• Learning mode for end positions activated
