Gehl GE 802, Руководство оператора

Страница: 44 / 52

Idler wheel should
be centered in
this opening
Side Plate
Adjustment
Fitting
Wrench
Grease Gun
PRINTED IN U.S.A.
4-14
90 8147 /0999
Changing Final Drive Oil
TRACK SYSTEM
1. Position the machine on a level surface with final drive
plugs positioned as shown in POSITION A, Figure 4-14.
Turn off the engine.
2. Open both plugs and drain oil into a suitable container.
Re-install plugs.
3. Turn the engine on and move the machine slightly until
plugs are positioned as shown in POSITION B, Figure
4-14. Turn off the engine.
4. Remove both screw plugs. Pour fresh oil (Gearoil EP 90
API GL 4) into the top hole until oil starts to run out of
the bottom hole.
5. Re-install both plugs securely.
IMPORTANT: Always dispose of oil according to
local regulations or take to a recycling center for
proper disposal. DO NOT pour fluids onto the
ground or down a drain.
1. Position the machine on a level surface.
2. Use the bucket and dozer blade to lift the unit up until
tracks are just clear of the ground. Turn off the engine.
3. Remove the side plate from the left track to expose the
adjustment fitting (Figure 4-15).
4. Using a grease gun, pump grease into the fitting until the
idler wheel is centered as shown in Figure 4-17.
NOTE: A grease gun is supplied with machine tool kit.
5. Install side plate.
6. Repeat steps 4 and 5 for right side track.
7. Start the engine. Lower the unit to the ground.
POSITION A
Screw Plugs in position
for draining oil
POSITION B
Screw Plugs in position
for Filling oil
Figure 4-14 Changing Final Drive Oil
Figure 4-15. Track Adjustment
Adjusting Track Tension