Gehl GE 802, Руководство оператора

Страница: 43 / 52

PRINTED IN U.S.A.
4-13
90 8147 /0999
Figure 4-13. Hydraulic Oil Tank
Filter
Gasket
Filter
Filter Cover
Drain Plug
Cap w/Strainer
1. Position the machine on a level surface.
2. Fully extend the bucket and boom. Lower bucket and
dozer blade to the ground (Figure 4-12). Turn off the
machine.
3. Slowly open the cap to relieve pressure (Figure 4-14).
Remove cap and clean strainer of any debris.
4. Open the drain plug (Figure 4-13) and drain oil into a
suitable container. Re-install drain plug and tighten
securely.
IMPORTANT: Always dispose of hydraulic fluids
according to local regulations or take to a recycling
center for proper disposal. DO NOT pour fluids
onto the ground or down a drain.
5. Remove bolts and filter cover (Figure 4-13). Remove
and discard old filter. Put clean hydraulic fluid on the
filter gasket and install gasket and new filter into tank.
6. Reinstall filter cover and bolts.
7. Fill tank with hydraulic oil until oil level is between red
and black marks on indicator (Figure 4-12).
8. Re-install hydraulic tank cap and tighten securely.
9. Start engine and let idle for a few minutes.
10. Check hydraulic functions. Recheck hydraulic oil level.
11. Reinstall access panel.
Changing Hydraulic Oil