Gehl GE 802, Руководство оператора

Страница: 41 / 52

PRINTED IN U.S.A.
4-11
90 8147 /0999
Using a Booster Battery (Jump Starting)
WARNING
Keep arcs, sparks, flames and lighted tobacco
away from batteries. When jump starting from
booster battery, make final connection (nega-
tive) at engine frame.
DO NOT jump start or charge a frozen battery.
Warm battery to 60°F (16°C) before connecting
to a charger. Unplug charger before connect-
ing or disconnecting cables to battery.
Battery gas can explode and cause serious
injury.
IMPORTANT: When jump starting from another
machine, be sure the second machine is not run-
ning while using the glow plugs. High voltage
spikes from a running machine can burn out the
glow plugs.
IMPORTANT: Damage to the alternator can
occur if:
• Engine is operated with battery cables dis-
connected.
• Battery cables are connected when using a
fast charger or when welding on the
machine. Remove both cables from the bat-
tery.
• Extra battery cables (booster cables) are
incorrectly connected.
Be very careful when jump starting the machine. Booster
battery must be 12 volt.
1. Turn ignition key to the off position.
2. Pull the valve cover latch lever (Figure 4-1) and open
the valve cover.
3. Connect one end of the cable to the positive (+) termi-
nal on the booster battery. Connect the other end of the
same cable to the positive (+) terminal on the machine
battery.
4. Connect one end of the second cable to the negative (-)
terminal on the booster battery. Connect the other end of
the same cable to the machine frame.
5. Start the machine engine. Once the engine is running,
remove the cable connected to the frame first.
Disconnect the other cable from the machine battery
positive (+) terminal.