Gehl GE 802, Руководство оператора

Страница: 38 / 52

Bolt
PRINTED IN U.S.A.
4-8
90 8147 /0999
Changing Engine Oil & Filter
ENGINE (continued)
1. Place the machine on a level surface. Run the engine
until it is at operating temperature, then turn the engine
off.
2. Pull the engine cover latch lever (located next the right
side of the operator’s seat) and raise the engine cover.
3. Remove the drain plug from the oil pan underneath the
engine and allow oil to drain into a container.
4. Remove the oil filter using a filter wrench.
5. Clean the filter housing surface. Put a film of clean oil
on the filter gasket. Install the new filter with gasket and
hand tighten.
6. Reinstall the drain plug.
7. Remove the oil fill cap from the engine (Figure 4-3).
Pour in new oil. Crankcase capacity is 6.1 qts. (5.7 L).
Reinstall oil fill cap.
8. Start the engine and let it run for several minutes. Stop
the engine and check for leaks at the oil filter and oil
drain plug.
9. Check the oil level again and add oil if necessary.
1. The air cleaner is located under the side cover. Pull the
side cover latch lever (located on the right-side of the
operator’s seat) and raise the side cover.
2. Turn the air cleaner cover bolt (Figure 4-4) to remove
the air cleaner cover and gasket.
3. Remove the wingnut (Figure 4-5) and remove air cleaner
element.
4. Clean air cleaner element with compressed air 30 psi
(200 kPa) (Figure 4-5).
5. Reinstall air cleaner element, wingnut, gasket, and air
cleaner cover. Tighten cover bolt.
6. Close valve cover.
IMPORTANT: Do not knock the element against
solid object to remove dust. The element may
become distorted and damaged.
Do not operate engine without the air cleaner ele-
ment installed or damage to the engine could occur.
Figure 4-3. Engine Oil Fill and Filter
Oil Filter
Oil Fill
Figure 4-4. Engine Air Filter
Figure 4-5. Servicing Engine Air Filter
Air Cleaner Service
Air Cleaner Cover
Gasket
Compressed Air
Wingnut