Gehl GE 802, Руководство оператора

Страница: 40 / 52

PRINTED IN U.S.A.
4-10
90 8147 /0999
Checking Coolant Level
Fuses
COOLANT SYSTEM
ELECTRICAL SYSTEM
Figure 4-9. Checking Coolant Level
Full
Low
1. Pull the engine cover latch lever (located next the right
side of the operator’s seat) and raise the engine cover.
2. Check the coolant level in the expansion reservoir
(Figure 4-9).
3. If low, slowly remove cap and fill reservoir to FULL
line.
WARNING
Engine must be cold. Be careful to avoid
burns when removing the cap. Keep face away
from cap. Cover cap with a cloth, turn cap
slowly to release pressure.
Refer to the engine manual for correct coolant
mixture for your engine.
The fuse panel is located on the right arm console
(Figure 4-10).
To replace a fuse, remove the panel cover and pull the old
fuse from the socket. Install a new fuse and re-install the
fuse panel cover.
Refer to page 3-3 in Section 3 for fuse identification.
The battery is located under the side cover, below the air
cleaner. To access the battery, pull the side cover latch lever
(located on the right-hand side of the operator’s seat) and
open the valve cover.
The battery cables must be clean and tight. Remove any acid
or corrosion from the battery and cables using a sodium
bicarbonate and water solution. Cover the battery terminals
and cable ends with battery saver grease.
The battery is maintenance-free and requires no other service.
Figure 4-10. Fuse Panel
Fuse Panel
Figure 4-11. Battery
Battery
Battery
WARNING
Batteries contain acid which burns eyes and
skin on contact. Wear safety goggles and pro-
tective clothing to keep acid off body.
In case of acid contact, wash immediately with
water for several minutes. In case of eye con-
tact, get medical attention immediately.