GE Voluson E Series, Руководство по обслуживанию

Страница: 337 / 356

10.4.3 Physical Inspection
Table 10-7 physical checks
Step Item Description
1 Labeling Verify that all ultrasound system labeling is present and in readable condition.
2 Covers Where applicable, verify all covers are secured in place and are properly aligned with other covers.
Replace any covers that are damaged.
3 Control Console
and Keyboard Inspect the control console and keyboard. Record any damaged or missing items. (Replace faulty
components, as required).
4 Control Console
Movement • Where applicable, verify ease of control console movement in all acceptable directions.
• Where applicable, ensure that it latches in position as required.
5 Control Console
Lighting Check proper operation of all control console.
6 LCD Monitor Inspect the LCD Display for scratches and bad pixels. Verify proper operation of Contrast and
Brightness controls. Where applicable, confirm that the LCD arm allows:
• swivelling the screen to the left and to the right
• folding the screen to the locked position
• release and adjustment backwards and forwards
• can be adjusted in the up/down positions
Note: LCD Arm movement may vary and is not applicable to all ultrasound systems.
7 Monitor Light Check for proper operation of any monitor lights, if available.
8 Cables and
Connectors Check all internal cable harnesses and connectors for wear and secure connector seating. Pay
special attention to footswitch assembly and probe strain or bend reliefs.
9 Shielding & Covers Check to ensure that all EMI shielding, internal covers, air flow panels and screws are in place.
Missing covers and hardware could cause EMI/RFI problems during scanning.
10 Probe Holders Where applicable, inspect the Probe Holders for cracks or damage.
11 Power and System
Status Indicators Check for proper operation of all Power and System Status Indicators.
12 External I/O Check all connectors for damage and verify that the labeling is good.
13 Wheels and Brakes • Check all wheels and casters for wear and verify operation of foot brake, to stop the system from
moving, and release mechanism.
• Check all wheel locks and wheel swivel locks for proper operation.
14 Battery Where applicable, check that the battery is not damaged, does not leak, does not emit an odor, and is
not deformed or discolored. Observe all warnings and cautions for battery handling, recharging,
storing, and/or disposal.
10.4.4 Cleaning
The Basic User Manual of the Voluson E-Series system provides a complete description of system/probe
care, maintenance, cleaning and disinfection.
Note It is the responsibility of the user to decide which cleaning procedures are necessary to ensure a safe
working environment.
Warning
•
Before cleaning the Voluson E-Series system switch it off and disconnect from AC mains.
•
Electric parts must be protected from liquids that drip or seep into the system.
•
Electrical contacts and connectors must not be cleaned.
•
Do not use high-proof alcohol for cleaning. Only use cleaning/disinfecting agents listed in the Basic
User Manual of the Voluson E-Series system.
Care and Maintenance
Voluson E-Series Service Manual
5539550APB Revision 6
10-7