GE SVI II AP, Быстрый старт

Страница: 46 / 92

© 2015 General Electric Company. All rights reserved
.
46 | = GE Oil & Gas
Configuration
Use the procedures that follow to: calibrate, tune, view configuration data and status messages
for the SVI II AP. Observe all warnings as the valve moves during these procedures.
WARNING
These procedures can cause the valve to move. Before proceeding
be sure the valve is isolated from the process. Keep hands clear
from moving parts.
NOTE All calibration and configuration procedures are described using
an SVI II AP with pushbuttons and display and ValVue software.
Configuration with Pushbuttons
Prior to changing the SVI II AP configuration, check the existing configuration.
Viewing Configuration Data
To view SVI II AP configuration data:
1. Access the VIEW DATA menu from the MANUAL menu by pressing the + button.
2. In the VIEW DATA menu, press * to examine the configuration.
3. Press + to scroll through and observe the factory configuration.
4. Press + until MANPOS appears.
5. Select with * .
6. When the adjustment screen appears stroke the valve open by h down.
The rate of set point change is slow to begin, but increases speed while the + is
pressed.
7. Stroke the valve to several values
8. Verify the action is as desired.
9. Press
+ to move to the SETUP menu.
10. In the SETUP menu press the * button to access the CONFIGuration menu.
11. In the CONFIG menu set the configuration parameters.
12. When in CONFIGure or CALIBrate , pressing * changes values.
13. Return to NORMAL mode. The valve moves to the value set by the current
calibrator.
14. Stroke the valve through its range to verify that the movement is as desired.