GE MDS entraNET Series, Руководство для стартапов

Страница: 14 / 32

12 MDS entraNET Start-Up Guide 05-4565A01, Rev. A
Ethernet Device Connection to Remote
NOTE: Verify that the Remote ETH port is enabled (on) using the
ETH
command. If it is not, use the
ETH=ON
command to enable the
port.
Connect an Ethernet endpoint to the Remote ETH port. The ETH port
supports any Ethernet-compatible device. This includes a device that
uses the Internet Protocol (IP).
Serial Device Connection to Remote
Connect a serial device to the Remote COM2 port and verify that the
port settings are compatible with the connected device (baud rate, data
format, etc.).
Step 7—Check for Normal Operation
In this step you will verify the proper operation of wireless communi-
cations between an Access Point and the associated Remotes.
At All Units...
Observe the transceiver LEDs on the top cover for the proper indica-
tions. In a normally operating system, the following LED indications
should be seen within 30 seconds of start-up:
• PWR— Lit continuously
•
LINK
—Lit continuously (unless Sleep is enabled)
• ETH —On, or blinks intermittently
•
COM1/COM2
—Blinks to indicate data communications
Table 3 on Page 13 provides details on the LED functions for Remotes
and AP radios.