GE MDS entraNET Series, Руководство для стартапов

Страница: 15 / 32

05-4565A01, Rev. A MDS entraNET Start-Up Guide
13
Table 3. Transceiver LED Functions
At the Access Point Unit...
a. If the Access Point unit is the fi rst unit you are installing, send
a
PING
command to it through the
LAN
port. This veri fi es basic
LAN
connectivity.
b. Connect to the radio’s management system via Telnet and
check for the list of connected Remotes.
c. Check the
Starting Information
screen for the
Device Status
. It
will show one of the following:
Operational
— The unit is operating normally.
Alarmed
—An alarm event has been logged and not cleared.
At Remote Units...
a. Look for the
LINK
LED to light and remain on. This indicates
the unit has successfully associated with the Access Point.
(Association may take several seconds.)
LED Label Activity Indication
LAN/ETH ON LAN or endpoint detected
Blinking Data TX or RX
OFF LAN or endpoint not detected
COM1
(MGT System) Blinking Data TX or RX
OFF No data activity
COM2 Blinking Data TX or RX
OFF No data activity
PWR ON Primary power (DC) present
Blinking Radio in “Alarmed” state
OFF Primary power (DC) absent
LINK (AP) ON Lights when radio has finished
its startup cycle. Remains lit.
LINK (Remote) ON Connected to an AP
OFF Not connected to an AP