GE Legend IP, Руководство пользователя

Страница: 24 / 140

Legend IP
User Manual
16
Using a keypad
The steps for accessing the programming interface from all GE keypads are similar. The following procedure is
based on the KTD-405 keypad, which is currently GE’s most popular keypad. Exceptions to the procedure for
other GE keypads are noted. You can also use the GE KTD-400 and KTD-404/304 keypads and other
manufacturers’ keypads and controllers using the Pelco D (autobaud), Pelco P, Tyco/AD (RS-422), Ultrak,
Impac (RS-485), and ASCII protocols. When using these other protocols, all standard commands are supported
by the Legend IP protocol, including pan, tilt, lens (zoom, focus, and iris), preset, and joystick control
commands for the specified third-party protocols. For details, see
Compatible protocol commands on
page 117.
To access the programming interface from a KTD-405 keypad:
1. At the normal display, press and hold the set
( ) key on the keypad until you hear a beep
and the programming code display appears
on the keypad’s LCD.
Figure 12. Normal display (programming interface accessed)
2. At the ENTER PROGRAMMING CODE
display, enter the programming access code
by pressing the
9 , 5 , 1 , and seq keys.
This code is the same for all GE keypads.
Figure 13. ENTER PROGRAMMING CODE display
3. At the equipment selection display, press 3 to
select CAMERA (keypad v1.2.09 or later) or
CAMERA/RCVR (keypad v1.1.06 or
earlier).
If you have an older keypad (v1.1.06 or
earlier), you will have a second equipment
selection display, at which you need to press
1 for CYBERDOME.
Figure 14. Equipment selection display
4. At the ENTER CAMERA SITE NUMBER
display, enter the number for the camera site
you are programming. This is a 3-digit
number (for example, 007, 021, 243).
You can enter one, two, or three digits and
press
set ( ).
Figure 15. ENTER CAMERA SITE NUMBER display
CAMERA 1
MONITOR 1
ENTER PROGRAMMING
CODE: _
1=SWITCHER/MPLX 2=ALARMS
3=CAMERA EXIT
1=SWITCHER/MPLX 2=ALARMS
3=CAMERA/RCVR EXIT
1=CYBERDOME 2=PTZ
3=AUXILIARY
BACK
v1.2.09
or later
v1.1.06
or
earlier
}
ENTER CAMERA SITE
NUMBER _ _ _
BACK