15
D0404SG0_B
KTD-404 Controller Keypad Installation and Operations Guide
System Component Programming
To program system components through a KTD-404 keypad, begin at the normal operating
display and proceed as follows:
Figure 23: Normal Operating Display
CAMERA 000
MONITOR 01
Step 1)
Press and hold the
set
key until the following display appears:
Figure 24: Code Entry Display
ENTER PROGRAMMING
CODE:_
Step 2)
Enter the access code
9
,
5
,
1
,
seq
. The display will automatically advance
to the next menu.
From this menu it is possible to perform video switcher programming, P/T/Z receiver
programming, alarm interface programming, and CyberDome programming by pressing the
corresponding number on the keypad.
P/T/Z receiver programming instructions can be found on the following pages. For detailed
programming instructions on the CyberDomes, alarm interfaces, and video switchers,
please refer to the product programming instructions.
If you are programming a CyberDome Day-Nite or CyberDome Select with a KTD-404
keypad, the
1st
key can be used to step backwards while in the programming menus.
NOTE:
Figure 25: First Menu Display
1=SWTCHR 2=RCVR 3=ALARMS
4=CYBERDOME SEQ=EXIT
