GE KTD-404, Инструкция по установке и эксплуатации, Страница: 3 / 12

11
D0404SG0_B
KTD-404 Controller Keypad Installation and Operations Guide
Multiplexer Enabled
Step 8) This menu determines which multiplexers can be enabled (accessed) from the
keypad. This must be done for each keypad in the system. To enable a
multiplexer, press
1
. When enabled, the Multiplexer Select Menu display
(Figure 16) will appear. Pressing
0
will advance to the next multiplexer in the
system. Moving the joystick up or down will switch between multiplexer brands.
Press
seq
to advance to the monitor offset menu display (Figure 18).
Multiplexer Select
Step 9) When a multiplexer has been enabled, this menu allows selection of different
models of multiplexers. Use the joystick to scroll through the list. The models are
listed in alphabetical order. After selecting the appropriate multiplexer, press
seq
to advance to the next menu.
Multiplexer View
NOTE:
Figure 17: Multiplexer View Display
VIEW: PIP YES
0=N 1=Y =NEXT SEQ=NEXT
Figure 16: Multiplexer Select Display
MPLXR 01: BURLE
SELECT ( ) SEQ=NEXT
Figure 15: Multiplexer Enabled Display
MPLXR 01 ACC=YES
0=NO 1=YES SEQ=NEXT
Monitor Access
Step 7) This menu is used to deny or permit the controller keypad’s access to certain
monitors. Press
0
to deny access or
1
to permit access. After each selection,
the next monitor number will appear. Move the joystick up or down to switch
between monitors. When done, press
seq
to advance to the next menu.
Figure 14: Monitor Access Display
MONITOR 01 ACC=YES
0=NO 1=YES SEQ=NEXT
If no multiplexers are enabled, the message “No multiplexers have been programmed” will
be displayed any time the key is pressed.
alt
Step 10) This menu determines which views will be enabled when the keypad is in
multiplexer operating mode. (When in multiplexer operating mode, pressing the
key toggles through the views selected here.) Move the joystick down to
scroll through the list of views available. For each view, press
1
to accept or
0
decline. When all views have been selected, press
seq
to return to the Multiplexer
Enabled menu display. Note: Some multiplexers do not allow specific view
selection and will skip this menu.
view