20
D0404SG0_B
KTD-404 Controller Keypad Installation and Operations Guide
Step 5)
Assign a preset position number (one or two digit depending on the receiver type
and largest preset number) using one of the two methods described below:
Method 1:
If the position is not to be included in the preset tour, enter the preset
number by using the number key(s). A tone will sound to acknowledge that the
position has been stored, and the display will return to Figure 42 to allow entry of
the next position.
Method 2:
If the position is to be included in the preset tour, enter the preset
number and hold the last digit entered until a tone sounds. The following display
will appear.
Step 6)
Repeat Steps 4 and 5 for each additional preset position. When done, press
seq
to exit to the menu shown in Figure 40.
Step 7)
Repeat Steps 2-6 for each camera site using preset positioning.
Use the numerical keys to enter the time that the camera should remain at the
position (1-31 seconds). The display will return to Figure 42 to allow entry of the
next position.
Figure 43: Preset Dwell Time Display
CAM 000 DWELL
(01-31 SEC) SEQ=EXIT
Store Preset Position
Step 4)
Use the joystick and related function keys (i.e.
zoom
in
,
out
zoom
, etc.) to move the camera
to the desired position.
Figure 42: Preset Display
CAM 000 POSITION?
CHOOSE(00-09) SEQ=EXIT
