GE IDP-1111, Руководство пользователя, Страница: 16 / 114

Legend
User Manual
8
When is logging on necessary
If passcodes were turned on (that is, specified) during installation or later, access to the programming interface
will be passcode-protected and you will have to log on to the dome to program it. Otherwise, you will be taken
directly to the main programming page from the keypad. The passcodes control who has access to the features
of your dome. See
Passcode page on page 23.
Starting from a keypad
The steps for accessing the programming interface from all GE keypads are similar. The following procedure is
based on the KTD-405 keypad, which is currently GE’s most popular keypad. Exceptions to the procedure for
other GE keypads are noted. You can also use the GE KTD-400 and KTD-404/304 keypads and other
manufacturers’ keypads and controllers using the Pelco D (autobaud), Pelco P, Tyco/AD (RS-422), Ultrak,
Impac (RS-485), and ASCII protocols. When using these other protocols, all common commands used for
accessing programming, operating the joystick and iris key on the keypad, and controlling presets are
supported by the Legend protocol. For an up-to-date list of compatible keypads and protocols, please contact
your GE sales representative or Technical Support.
To access the programming interface from a KTD-405 keypad:
1. At the normal display, press and hold the set
( ) key on the keypad until you hear a
beep and the programming code display
appears on the keypad’s LCD.
Figure 2. Normal display (programming interface accessed)
2. At the ENTER PROGRAMMING CODE
display, enter the programming access code
by pressing the
9 , 5 , 1 , and seq keys.
This code is the same for all GE keypads.
Figure 3. ENTER PROGRAMMING CODE display
3. At the equipment selection display, press 3
to select CAMERA (keypad v1.2.09 or later)
or CAMERA/RCVR (keypad v1.1.06 or
earlier).
If you have an older keypad (v1.1.06 or
earlier), you will have a second equipment
selection display, at which you need to press
1 for CYBERDOME.
Figure 4. Equipment selection display
CAMERA 1
MONITOR 1
ENTER PROGRAMMING
CODE: _
1=SWITCHER/MPLX 2=ALARMS
3=CAMERA EXIT
1=SWITCHER/MPLX 2=ALARMS
3=CAMERA/RCVR EXIT
1=CYBERDOME 2=PTZ
3=AUXILIARY BACK
v1.2.09
or later
v1.1.06
or
earlier
}