Appendix B — Humilab chilled mirror hygrometer details
Page
51
the parameter for the Humidity output and the scaling. For
now, press
N
. You can now do the same for the bottom display.
The units that you can select in the Units mode are shown in Table
7:
Table 7: Electronics Module Unit Selection
When you see the parameter you want to display, press
S
to select
it. You can have the Electronics Module display a subset of its
default parameters. See the RS-232C communications information
in Appendix C for details.
• The
CONTROL STATUS
display now shows “
O
.” Press
S
to view
the output(s). The
CONTROL STATUS
display shows “Humid-
ity.” The current high value for the humidity output is shown.
Press
N
to view the low value. Press
N
again. You will then be
able to view the high and low values for the Temperature out-
put. When you are done, press
N
to move on.
Changing output(s).
You can modify the behavior of the
DISPLAY
switch so that the output units and scaling
ON/OFF
limits are
hidden from view or are viewable and changeable. See the RS-232C
Communications information in Appendix C for details. The
following section describes how to change the analog output(s)
units and scaling using the
DISPLAY
switch. Once again, you can do
this only after you have changed the default behavior of the
DISPLAY
switch.
Display Units
Parameter Flag
Explanation
°C
Humidity
Dew Point, °C
°F
Humidity
Dew Point, °F
H
Humidity
Relative Humidity,%
°C
Temperature
Temperature, °C
°F
Temperature
Temperature, °
F
Содержание HumiLab
Страница 43: ...Chapter 5 Maintenance and Troubleshooting Page 39 Figure 13 Mirror Check and Mirror Sensor Balancing Procedure ...
Страница 75: ...Appendix D Humidity Equations and Conversion Charts Page 71 Figure 16 Graphical Conversion Chart ...
Страница 76: ...Page 72 Appendix D Humidity Equations and Conversion Figure 17 Psychrometric Chart ...
Страница 80: ...Page 76 Appendix E Warranty information and return ...
