GE AquaTrans AT868, Руководство пользователя

Страница: 50 / 158

Programming Site Data 2-25
September 2004
Setting Up the Inputs and
Outputs - GLOBL-I/O
Set up the AT868’s inputs and outputs via the
Input/O
utput submenu.
While following the programming instructions, refer to Figure A-2 in
Appendix A,
Menu Maps . Remember to record all programmed data
in Appendix C, Data Records .
The
GLOBL-I/O
submenu consists of the following:
• ERROR
- program the meter’s response during an error condition -
see below.
• OPTN
- set up the analog and totalizer/frequency outputs -
page 2-28.
• LCD
- set up the LCD display (refer to Chapter 3, Setting Up the
Display on page 3-2).
Selecting Error Handling -
ERROR
This menu option lets you set how the AT868 will handle the outputs
for measurements and average (two-path) measurements during an
error condition. See Chapter 5,
Error Codes , for a discussion of the
built-in error codes.
Use the steps below to select error handling options.
1.
Press [ESC],
[ENTER]
, [ESC]. The meter enters the user program.
2.
Press [
X
] until
PROG
appears and press
[ENTER]
.
3.
Press [
X
] until
GLOBL
appears and press
[ENTER]
.
4.
Press [
X
] until
I/O
appears and press
[ENTER]
.
5.
Press [
X
] until
ERROR
appears and press
[ENTER]
.
6.
Press [
X
] to select the desired option for error handling and press
[ENTER]
. See Table 2-4 and Table 2-5 on the following page for a
description of error handling options available and how the
totalizers and display responds to them for a 1- and 2-channel/path
meter.