Kalatel DVSe
10
0150-0178F
Motherboard Overview
IDE Power
Connectors
IDE
Connectors
Power
Supply
Load
Resistors
Jumpers
2.3 Configuring Master/Slave
Hard drives are connected in pairs to
each of the four IDE connectors. Each
pair of hard drives must be configured
as a Master and a Slave. Configure
the Master/Slave settings on each hard
drive individually using the jumpers
provided with the drive. Use the
diagram located on the hard drive to
determine the proper jumper
configuration.
If a single drive is connected to an IDE
connector, it must be configured as a
Master.
IDE Connector #1
IDE Connector #2
IDE Connector #3
IDE Connector #4
Disk 1 Master
Disk 2 Slave
Disk 3 Master
Disk 4 Slave
Disk 5 Master
2.4 Mounting The Hard Drives
Remove the Hard Drive Support Bracket. This entails removing the screws at
either end and one screw from each installed hard drive.
Orient the hard drive so that the IDE Power Connector is near the bottom of the
chassis and facing the motherboard. Populate the drive array in order, starting
from the left.
Fasten the drive in place using the supplied screws. Fasten each drive using two
screws through the bottom of the chassis and one screw in the Hard Drive
Support Bracket.
