0150-0178F
11
Kalatel DVSe
2.5 Connecting the Hard Drives
Power Supply Cables
It is recommended, for ease of installation, that the IDE and power
cables be first connected to the drives before the drive screws are
tightened.
Connect the hard
drives to the power
supply connectors
with power supply
cables.
When connecting a
single drive to a
cable, attach the
drive to the
connector at the end
of the power cable.
Disk 1
Disk 2
Disk 3
Disk 4
Disk 5
Disk 6
Disk 7
Disk 8
Power Supply
Mother Board
The diagram above shows a typical connection. The connections
may vary according to the number of drives in the system and the
power cable type.
IDE Data Cables
Use an IDE cable to connect the drives as shown in the diagram in section 2.3.
When attaching the IDE connector, make sure the connectors are oriented
properly.
Connecting To The Motherboard
The red stripe on the connection ribbon
should connect nearest the Pin 1 indicator
on the motherboard.
Pin 1
Indicator
Connecting To The Hard Drive
The red stripe on the connection ribbon
should connect near the jumpers on the hard
drive.
Pin 1 Near
Jumpers
NOTE
NOTE
