13
Figure 8
Figure 8 shows the test results of three times, "signal type" is double
locking. Click "start" to clear the displayed value and detect again. Click "save"
and "print" to save and print the test results.Click "return" to return to the
density relay parameter setting interface.
1. Calibration of normal temperature pressure gauge
On the main interface, select "normal temperature pressure gauge
calibration" and click "select" to enter the normal temperature pressure gauge
calibration program, as shown in Figure 9.
Figure 9 is the parameter setting interface of normal temperature pressure
gauge calibration. Two parameters, temperature acquisition and pressure
target value, can be set by operating the rotating mouse.
Figure 9
The setting of "temperature acquisition" is the same as the setting in
"density relay verification". The "pressure target value" is the preset pressure